Q-See QSD6204 Specifications

B. Camera Installation (1) For cameras that have no built-in microphone If your cameras have cables consisting of power and video cables, c

(2) For cameras that have a built-in microphone If you’re purchased cameras that have a built-in microphone, follow the diagram below for

C. Sensor Installation The DVR can support up to 4 sensors (not included in the DVR package) in up to four locations. There are two steps for sensor i

D. Alarm Installation The DVR has an internal switch for sounding an alarm. The switch is normally open, but when the sensor is triggered, th

E. LAN-DVR Connection See the diagram below for steps to connect your DVR to a local area network or the internet. For remote monitoring from you

F. Power Connection Connect the DVR power adapter at the back of the DVR unit. Notice: We also STRONGLY recommend that you plug the

Chapter 5. DVR Menu Below you will find a screen shot of the DVR main menu. Press the MENU button to display the screen. Main menu P

1. Camera Setup There are 4 cameras that can be connected to the DVR. Use the key buttons on the front panel to select which cameras are turned

2. Record Setup SELECT CAMERA(S) FOR RECORDING Selecting the camera channel/s on RECORD SETUP menu is the same as CAMERA SETUP options.

3. Record Frame Rate ADJUST BETWEEN 1 TO 25 (PAL) OR 1 to 30 (NTSC) FRAMES PER SECOND The total frame rate per second is 50/60.You can set t

Table of Contents Chapter 1.Introduction to the Digital Video Recorder (DVR)……………………………………………..…..1 Chapter 2. Unit Description…………………………………………………………

5. Record Schedule The time line below indicates the hours of the day based on an AM/PM clock. For each hour you may select between NO RECORD, RECORD

6. Sensor Setup Notice: You need to buy sensors separately to make sensored alarm recording functions operate on your DVR system. MOTION SE

In this example, Channel 1 has sensors installed, Open and Close, respectively. MOTION DETECTOR SETUP This indicates the sub menu for

7. Hard Drive Setup HARD DRIVE INFORMATION 1.OVERWRITE ENABLED: If you choose YES (default setting), recording continues and overwr

7.1 Hard Drive Format When you press the “SELECT” key you will be prompted to input a Password when the hard drive format menu appears. Type Passw

8. Miscellaneous Setup .CHANGE PASSEWORD .SET TIME .HIDDEN CHANNEL(ON/OFF) .AUDIO PORT SETUP .PTZ SETUP .COLOR SETUP .PASSWORD CONTROL

(1) PASSWORD CHANGE ·6-DIGIT PASSWORD ·DEFAULT PASSWORD SETTING: 111111 When you select “CHANGE PASSWORD”, the menu below will open.

(2) SET TIME You can change year/date/hour/minute/second by using the SET TIME menu. .Year .Date .Hour .Minute Second 2007/11/11=

(4) AUDIO PORT SETUP AUDIO CHANNEL NUMBER AUDIO RECORD, MUTE YES/NO When you move the cursor to “AUDIO PORT RECORD” and push t

For Example The setup screen for the above configuration would look like this: (5) PTZ SETUP This DVR can control speed dome cam

GENERAL SAFETY Review the following safety precautions to avoid injury and prevent damage

6 COLOR SETUP .CON .BR1 .HUE .SAT -27- (7) PASSWORD CONTROL

·PASSWORD CONTROL 9. Network Setup NETWORK SETUP Note: The default MAC address is: “00-11-22-33-44-55”, but af

Accessing the DVR over a network To access the DVR through a computer you need to make sure the default gateway on the DVR is the same IP a

Accessing the DVR from a remote computer To access the DVR from a remote computer, in addition to the above steps, you will also need to forward port

Static verses dynamic addresses: You can access the DVR through a static or dynamic IP address, however a dynamic address can change from time to t

10.VIDEO BACKUP VIDEO BACKUP

11. Reset Menu RESTORE FACTORY DEFAULT SETTINGS Selecting ‘RESET MENU’ will restore all of the factory default settings for the DVR.

A. Record Control RECORDING BY CAMERA When the “RECORD” button is pressed, the recording process starts immediately. The recording channel indicato

PLAYBACK CONTROL To manually input a specific time to be viewed: 1. Open the SEARCH TIME window by pressing the “MENU” button during “

B. Record Mode If you press the “REC” button, the DVR goes into “REC” mode. The DVR will start recording based on set “Record Schedule”. In reco

Chapter 1. Introduction to the Digital Video Recorder (DVR) The following document is a reference for Vineyard Teneyard Technologies’ Digital Sec

Chapter 6. USB Programming (optional) 6. USB Programming 6.1 Install 1. Place the USB Driver Program CD into your CD ROM. 2. If your CD ROM does no

Button functions: 1.PTZ Control 11.Record 2.Zoom in, Zoom

Press (button 6) to open the video event lists. Press (button 7) to configure the DVR play/record system.

Chapter 7. Trouble Shooting Guide 1. What kind of camera should I buy for this DVR? Any BNC or RCA interface indoor/outdoor/infrared camera w

12. Can I still record all the events while I review the previous recording? No. This DVR currently doesn’t support recording while playback. 13.

Appendix Technical Specifications 4-Channel DVR Items Descriptions Video Standard NTSC, PAL Video Input/Output 4 Channels/2 Channels Audio Input/Ou

-42- Recording Time Table (Per 160GB of storage with the installation of 4 cameras.)

Q-SEE Product Warranty Thank you for choosing our products. All of our products users have a conditional free war

Customer Information Card User’s Name Mr./Mrs. Company Name Postal Address Postal code Phone Number E-mail Model Number of Product Seri

Chapter 2. Unit Description A. DVR Front Panel This chapter briefly describes the buttons on the front panel of the DVR. These buttons operate the ba

(6) REW To play the recorded video backward, press the “REW” button. There are 6 modes of REW, 1~6.To change the reverse playback speed level, press

B. DVR Rear Panel. [Note] See “Chapter 4. Hardware Installation” for more details. (1) VIDEO OUT Connect DVR to TV monitor using a RCA cable

Chapter 3. Getting Started (1) Install a hard drive into your DVR (some models come with the hard drive already installed). (2) Connect the DVR to

Chapter 4. Hardware Installation A. Connecting DVR to Your TV Set (1) Video Input/Output Connection (For TV monitor screen d