Q-See QT8216 Service Manual Page 11

  • Download
  • Add to my manuals
  • Print
  • Page
    / 12
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 10
11
REMOTE CONNECTION
When not directly connected to an NVR, it can be directly accessed using a computer, mobile
phone or tablet. The camera will need to be connected to the Internet through a local network
using a standard Ethernet cable and its IP address must be obtained following the steps below. If
you’ve already followed these steps to connect to the camera from an NVR, you may skip to the
sections covering use on a computer or mobile device.
STEP 1. Connect the camera to a POE Injector, such as Q-See’s QAPE model.
STEP 2. Plug the injector into a power outlet.
STEP 3. Use a network cable to connect the injector to a network port.
PICTURE 20
PICTURE 21
NOTE!
The IP address shown is
only for your local network. The
NVR cannot use this to connect
to the camera over the Internet.
OBTAIN IP ADDRESS:
STEP 4. Download and install the IP
Tool sofware onto a Windows PC
connected to the same network as
the remote camera.
STEP 5. Launch the IP Tool sofware.
It will locate the camera and display
its information. Mac users will need to
install CMS or NVMS.
Browser - Windows Internet Explorer
Fine 100%
Open Port Check Tool
Page Safety Tools
hp://canyouseeme.org/
Protected Mode: On
Your IP: 81.919.622.24
What Port?
CanYouSeeMe.org - Open Port Check Tool
Check
This page will serve as a free utility for remotely verifying a port is open or closed. It will
be useful for users who wish to check to see if a server or ISP is blocking certain ports.
Success: I can see your service on
81.919.622.24 on port (85)
Your ISP is not blocking port 85
PICTURE 22
CONFIRMING THAT PORTS ARE OPENED
Like your NVR, your cameras feature UPnP technology that allows them to communicate
with the network and through to the Internet. Two “ports” (think of them as doorways through
the firewall) are used; 85 and 6036. You will want to verify that these have been automatically
opened by using an online tool at www.canyouseeme.org using the same computer.
STEP 6. Enter “85” into the box labeled
“What Port?”
STEP 7. Click on the Check button.
STEP 8. You should see a green
“Success” message.
STEP 9. Repeat for port 6036.
Page view 10
1 2 ... 6 7 8 9 10 11 12

Comments to this Manuals

No comments