Q-see QT528 User Manual download pdf (Page 32)

Step 1: Enter into system configurationalarm configurationvideo loss; refer to Fig 4-27:

Fig 4-27 Alarm Configuration-Video Loss

Step 2: The setup steps of video loss trigger are familiar with alarm handling; user can refer to Chapter 4.5.1 Sensor

alarm handling for more details.

Step 3: User can setup all channels with same parameters, checkmark “all”, then to do relevant setup.

Step 4: Click “default” button to restore default setting; click “apply” button to save the setting; click “exit” button to

exit current interface.

4.5.4 Other Alarm

Fig 4-28 Other Alarm

Step 1: Enter into system configurationother alarm; refer to Fig 4-27:

Step 2:

select a hard disk in the pull down list box, when the disk capacity is lower than that value, there will

appear some text information on the lower right of the live image.

IP conflict: if there is an IP address conflict within the same network, the device will auto send an email to users

designated mailbox to notify the conflict details.

Disconnect: if the disconnect happen, the device will auto send disconnection information to users designated

mailbox.

Step 3: Click “default” button to restore default setting; click “apply” button to save the setting; click “exit” button

to exit current interface.

4.5.5 Alarm Out

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 97 98

No comments

Q-see QT528 User Manual Page 32