Q-see QT528 User Manual download pdf (Page 53)

Fig 7-6 PPPoE

DDNS: You can access the DVR through a static or dynamic IP address; however a dynamic address can

change from time to time. How often depends on your service provider. When it changes you need to go to a

website such as www.myipaddress.com from a computer attached to the same router as the DVR to find out

what the new IP address is. There are two solutions to this problem. One would be to get a static IP address

from your service provider so that you do not have to be concerned with the address changing. Another solution

would to use a dynamic domain name service to get a domain name that can be linked to your dynamic IP

address. We suggest myq-see.com or www.dyndns.com since the DVR is setup to accept account information

from these two domain name services.

NOTE: Before you setup DDNS you must first set up Port Forwarding as directed in Section 7.3 PORT

FORWARDING

To setup the DVR for access through a dynamic domain name you go to the Main Menu and select the System

icon (Red box in Fig 7-1), then select the Network icon (Red box in Fig 7-2), this will display the NETWORK

screen shown in Fig 7-7. Put a checkmark in the DDNS option (Red box in Fig 7-7). Select the service you are

using from the drop down menu under the checkmark box and enter the account information you registered with

the domain name service. Click the Test button under the boxes where you entered the account information and

after you get the OK message in the lower left hand corner of the screen click on the Apply button . You will then

be able to access the DVR remotely by entering the domain name into a browser window on a remote computer.

This DVR supports DDNS provided by myq-see.com and www.dyndns.com. Instructions for setting up DDNS

through mwq-see.com is provided below:

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 97 98

No comments

Q-see QT528 User Manual Page 53